Water Quality and Maintenance page 31
Freshwater
ag+
SIlVER ION SYSTEM
The silver ion system is comprised of the following products:
•
FReSHWateR
sodium dichlor
•
FReSHWateR
Monopersulfate (MPs)
•
FReSHWateR
ag+
silver ion purifie
•
CleaN SCReeN
Pre-Filter
CleaN SCReeN pre-Filter
is used when filling a spa for the first time, at top off, or at refill. It attaches to a garden hose and filters out rust, dirt,
detergents, algae and chemicals.
FReSHWateR Sodium Dichlor (chlo rine)
is the only recommended sanitizer that will work in conjunction with all of the other products in this
system..
FReSHWateRmonopersulfate (mpS)
is an oxidizing chemical used to prevent the buildup of contaminants, maximize sanitizer efficiency, minimize
combined chlorine, and improve water clarity.
FReSHWateR
ag+
silver ion purifier
introduces silver ions into the spa water, inhibiting bacteria growth. When combined with MPs, or chlorine,
oxidizes particulates in the spa water.
It is important to follow the recommended application and maintenance programs outlined for each product’s use.
If the spa is being used over an extended period of time, such as a whole afternoon or evening, additional sanitizer will be needed.
a weekly “shock treatment” is required.
The shock treatment quickly destroys any remaining contaminants while revitalizing the silver ion cartridge, allowing the silver ions to continue to be
released into the water. Without this weekly shock treatment, the silver ion cartridge may stop releasing silver ions into the water.
To weekly “shock treat” your spa you may use either MPs or sodium dichlor. It will require much less sodium dichlor to administer the shock
treatment than MPs (one teaspoon of sodium dichlor has oxidizing capabilities comparable to two tablespoons of MPs). sodium dichlor may be
a more appropriate weekly shock for those users that experience heavy bather load conditions.
ImpoRtaNt Note:
MPs is an oxidizer, not a sanitizer.
everFresh
WATER CARE SYSTEM
The
eVeRFReSH
water care system is comprised of the
FReSHWateR
Ag+ silver ion and the
FReSHWateR
III high output ozone system
FReSHWateR ag+ silver ion System
(see above).
FreshWater III high output ozone system (optional)
uses corona discharge technology to produce a high concentration of ozone, which is
injected into the spa water
FReSHWateR
Ag+
SIlvEr Ion purIFIEr rEplACEMEnT InSTruCTIonS
When replacing the
FReSHWateR
ag+
silver ion purifier (every four months) it is highly recommended that the spa be drained and refilled at the
same time. After refilling the spa with water, balance the Total Alkalinity (TA), calcium Hardness (cH) and pH to the recommended levels. shock
the spa by adding sodium dichlor (see sanitization Table for details).
1. Fold back the vinyl cover.
2. Remove any floating items within the filter compartment.
3. Locate the filter retainer handle. Turn the filter retain handle counterclockwise until the cap can be removed from the filter standpipe.
4. Remove and clean filter cartridges.
Note:
When replacing the
FReSHWateR
ag+
silver ion purifier, it is an excellent time to clean the filter to extend the life. Remove the existing
FReSHWateR
ag+
silver ion purifier.
5. Install the new
FReSHWateR
ag+
silver ion purifier into the filter standpipe as illustrated in the silver Ion instructions.
6. Reinstall the cleaned filter cartridges.
7. Replace and secure the filter retainer handle or filter basket and cap.
8. Fold the cover back into place.
WaRNING:
Never use the spa with the filter cartridges or filter standpipes removed!
Summary of Contents for 2014 REL
Page 1: ...2014 Owner s Manual...
Page 47: ......
