CAUTION:
Surfaces may become hot
and cause burns if electronics get wet. Do not
operate vehicle through water or snow.
GET STARTED!
Your vehicle has an amazing Gyro Stabilizer that makes it easy to drive
– and lets it perform amazing stunts! The stabilizer safely spins at high
speed inside the rear wheel, and it works like a gyroscope to help keep
your vehicle upright.
1.GET SET!
Energize the gyro stabilizer! Hold the vehicle off the ground and push the
left control all the way forward. Once the gyro stabilizer spins up to full
speed, you’ll be able to hear it – and if you twist the vehicle form side to
side you’ll really feel it working!
*
Be sure to keep your fingers clear of the wheels at all times.
2.LAUNCH IT!
Gently hand-launch your vehicle. Set it on the ground and give it a gentle
push while pushing the left control forward. Now you’re ready for the
coolest stunt driving!
I. CONTENTS/ FEATURES
• XTREME MOTO-CROSS CYCLE Vehicle
• TYCO® R/C TMH® NiMH Charger
• TYCO® R/C TMH® FlexPak® NiMH Battery Pack
• 9V Battery for Transmitter
• Transmitter
FEATURES
• Full function
• Available in 2 frequencies (refer to labels on transmitter & vehicle for
frequency)
• Range up to 65’/20m
VEHICLE
q
Articulated Rider Figure
w
Powerful Motor
e
Gyro Stabilizer (inside rear wheel)
r
Heavy-Duty Suspension
t
ON/OFF Switch
y
Battery Compartment
u
Battery Latches (2)
TRANSMITTER
NOTE: Your transmitter is equipped with a special automatic ON
battery-saving feature. Just turn your vehicle ON. Then push either
transmitter control and you will be able to run and control your vehicle.
A
Left Control: Forward & Braking
B
Antenna
C
Right Control: Turning
M2933-0920
Keep these instructions for future reference as they
contain important information. IMPORTANT: Please
read all “Consumer Information” before operating
your vehicle.
1.
2.
XTREME
XTREME
MOTO-CROSS CYCLE
MOTO-CROSS CYCLE
XTREME
XTREME
MOTO-CROSS CYCLE
MOTO-CROSS CYCLE
NOT RECOMMENDED
FOR CHILDREN UNDER
8 YEARS OF AGE. AS WITH ALL ELECTRICAL PRODUCTS, PRECAUTIONS SHOULD BE
OBSERVED DURING HANDLING AND USE TO REDUCE THE RISK OF ELECTRIC SHOCK.
INPUT: 120VAC, 60Hz,0.11A. OUTPUT: 8.5VDC, 370mA , 3.2VA.
CAUTION-ELECTRIC TOY:
C
B
A
®
