7
SAUNA HEATER WIRING AND
HOOKUP
Refer to table below for proper wire size
and amperage. See page 5 and 6 for
required clearances. Any wiring within
internal sauna walls must be rated 194°F
(90°C) and copper wire must be used. Run
wire through seal tight flex conduit from
wall to heater and connect to junction
box at back of heater with 194°F (90°C)
connector. Connect to terminals 1 and 2
and connect ground wire to lug marked
ground. (Cover plate under heater must
be removed first.)
Note! If connection to heater will be made
at a later time, bring flex into sauna room
4 - 6” from floor, and leave 3’ of flex for
hookup (can be cut to right length later).
SAUNA CONTROL PANEL WIRING
AND HOOKUP
Refer to HeatPad installation and
operation manual.
Models P300/KIP30W1, P450/KIP45W1,
and P600/KIP60W1
require a HeatPad10/
CX30-U1-U3 sauna heater control.
Follow 240V 1Ph (single circuit) wiring
on ProHeat series wiring schematic (page
14 of HeatPad installation and operation
manual).
Model P800/KIP80W1
requires a
HeatPad15/CX45-U1-U3 sauna heater
control. Follow 240V 1Ph (single circuit)
wiring on ProHeat series wiring schematic
(page 14 of HeatPad installation and
operation manual).
Models P600-3/KIP60W3 and P800-3/
KIP80W3
require a HeatPad10/CX30-
U1-U3 sauna heater control. Follow 208V
3Ph wiring on ProHeat Series wiring
schematic (page 14 of HeatPad installation
and operation manual).
Note! All ProHeat sauna heater hookups
require a 10 AWG jumper wire from A1
to A2 on power unit terminal block. See
ProHeat series wiring schematic (page
14 of HeatPad installation and operation
manual).
SAUNA HEATER (240 V) WITH CONTROL UNIT
Model
kW
Amps Voltage Phase Wire Size Control
P300/KIP30W1 3.0
12.5
240
1
12
HeatPad10/CX30-U1-U3
P450/KIP45W1 4.5
18.8
240
1
10
HeatPad10/CX30-U1-U3
P600/KIP60W1 6.0
25.0
240
1
10
HeatPad10/CX30-U1-U3
P800/KIP80W1 8.0
33.3
240
1
8
HeatPad15/CX45-U1-U3
SAUNA HEATER (208 V) WITH CONTROL UNIT
Model
kW
Amps Voltage Phase Wire
Size
Control
P600-3/
KIP60W3
6.0
16.7
208
3
12
HeatPad10/CX30-U1-U3
P800-3/
KIP80W3
8.0
22.2
208
3
10
HeatPad10/CX30-U1-U3