User Manual: HotDog
TM
Patient Warming System Controller
Page 9
Controller will beep. Afterwards, the software version is displayed for approximately 2
seconds. The Mains Power ON Light will illuminate and the Controller will remain idle until a
warming device is plugged in. When the unit is ON and idle (i.e., no Temperature Setting
Lights are illuminated), no power is applied to the warming device and no alarm conditions are
indicated.
Temperature Adjust Button / Temperature Setting Display
When a warming device is plugged into a port, an audible beep will sound and the display will
show two dashes. Press the Temperature Adjust Button for the desired port until the desired
temperature is displayed. The temperature can be selected in one degree increments from 37-
43°C for Ports A and B (Warming Blankets) and 35-39°C for Port C (Warming Mattresses).
The designated warming temperature will flash until the selected temperature is achieved, at
which time the selected temperature will steadily display.
Port A, B and C
Ports A and B are used only for HotDog Warming Blankets, and Port C is used only for
HotDog Warming Mattresses. When a warming device is plugged into the Controller, an
audible beep indicates that the control and over temperature sensors are present and functioning
properly.
Port D and E
Ports D and E supply a 48V output for future approved HotDog accessories; at this time there
are no accessories manufactured for use on these ports.
