User Manual: Hot Dog Veterinary Patient Warming System Controller
Page 8
Mains Power Switch / ON Power Indicator
When the Hot Dog Controller is plugged into an electrical outlet and the Mains Power Switch on
the back of the Controller is turned ON, all displays will illuminate briefly, and the Controller
will beep. Afterwards, the software version will display for approximately 2 seconds. The Mains
Power ON Light will illuminate and the Controller will remain idle until a warming blanket is
plugged in. When the unit is ON and idle (i.e., no Temperature Setting Lights are illuminated), no
power will be applied to the warming blanket, and no alarm conditions will be indicated.
Temperature Adjust Button / Temperature Setting Display
When a warming blanket is plugged into a port, an audible beep will sound, and the display will
show two dashes. Press the Temperature Adjust Button for the desired port until the desired
temperature is displayed. The temperature can be selected in one-degree increments from 37-
43°C for Ports A and B. The designated warming temperature will flash until the selected
temperature is achieved, at which time the selected temperature will steadily display.
Port A and B
Ports A and B are used only for Hot Dog Warming Blankets.
Port C, D and E
Ports C, D and E are for future Hot Dog veterinary accessories; at this time there are no
accessories manufactured for use on these ports.
Alarms
Alarm: Port A and B
If the warming device sensor temperature exceeds one degree above set point or other fault
conditions exist, an audible alarm sounds and the Alarm Light for the affected port illuminates
