8
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• To identify small parts, see page 7.
• Assembly requires the following tools (not
included):
one 3/8" hex key
one 7/32" hex key
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
ASSEMBLY
1. Place the Base Frame (56) on two pieces of the wood
(A) found in the packaging of the incline trainer. Position
the wood on each side of the Base Frame behind the
feet as shown.
Have a second person hold the Upright (93) near the
front of the Base Frame (56) as shown.
As you insert the Upright (93) into the Base Frame (56),
insert the Frame Wire Harness (129) through the bracket
on the Upright and into the large hole in the front of the
Upright. Be careful to avoid pinching the wire.
Align the holes in the Upright (93) with the holes in the
Base Frame (56).
93
56
1
Hole
129
2
2. Locate the Frame Wire Harness (129) and the Upright
Wire (116) in the Upright (93) access hole.
Connect the Frame Wire Harness (129) to the Upright
Wire (116) at the front of the Upright (93). See the inset
drawing. The connectors should slide together easily
and snap into place. If they do not, turn one connector
and try again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY BECOME
DAMAGED WHEN YOU TURN ON THE POWER.
129
116
93
129
116
A
