6
1
60
60
2
1
39
Wire
Harness
Avoid pinching the
wire harness
1.
Orient the Shield Cover (39) and the Upright (2)
as shown. Slide the Shield Cover upward onto
the Upright.
While a second person holds the Upright (2)
near the Frame (1), insert the wire harness
upward through the Upright.
Tip: Use an elas-
tic band or a piece of tape to prevent the
upper end of the wire harness from falling
into the Upright.
Tip: Avoid pinching the wire harness.
Attach
the Upright (2) to the Frame (1) with four M8 x
20mm Screws (60).
Tip: Start all the Screws
before tightening any of them.
Then, slide the Shield Cover (39) downward to
the bottom of the Upright (2).
Attach the Cup Holder (19) to the Upright (2)
with two M4 x 15mm Screws (52).
2. Attach the Right Handlebar Leg (32) to the Right
Pedal Leg (28) with an M8 x 32mm Screw (63),
four 5mm Bushings (56), and an M8 Locknut
(54).
Do not overtighten the Locknut; the
Right Pedal Leg must pivot
easily.
Attach the Left Handlebar Leg (not shown) to
the Left Pedal Leg (not shown) in the same
way.
63
32
28
54
56
56
2
52
19
To make assembly easier, read the
information on page 5 before you begin.
