Programmable Single Stage Thermostat
Reference No.:
HTW-ST01-B
- 5 -
Version 2019-1.0
Setting the temperature
Set the
SYSTEM
switch to either
HEAT
or
COOL
, then press the
▲
or
▼
button until the temperature you want to maintain is
shown on the right side of the display. If you want to turn the system off, just move the
SYSTEM
switch to the
OFF
position and the
FAN
switch to the
AUTO
position.
Clock setting
Press the
TIME
button to enter into clock/week setting, press ▲ or ▼ buttons to adjust respective values.
Hour-Minute-Week
Please adjust the hour correctly that associate with actual AM/PM.
Filter review
Move the
SYSTEM
switch to the
HEAT
or
COOL
position, then press and hold the
▲
and
▼
buttons for 5 seconds to review filter
running days. To exit the review menu press the
▲
or
▼
buttons one time. Or If no buttons are pressed within 15 seconds, the
thermostat will exit the configuration menu.
In review mode, press and hold the ▲
and ▼
15 sec. to clean the filter warning. It will show “dEF” blink.
Child Lock
Quickly and simultaneously press the
▲
and
▼
three times to lock the temperature adjustment, and again to unlock.
RESET function.
This function can help operator to recovery system when fault happened, display out of order or system halted. Please use a pin
to insert in button RESET hole till sounded click, then loosen it.
Hold Temperature
With the
SYSTEM
switch set to
HEAT
or
COOL
, momentarily press the
HOLD
button.
HOLD
will be displayed. Use
the
▲
or
▼
buttons to adjust the temperature. The thermostat will control the room temperature at the selected setting
until you press the
RUN
button to restart the program operation.
Temperature Override
(When in the program
RUN
mode)
.
Press the
▲
or
▼
buttons to select the desired room temperature. The thermostat will override the current programming and keep the
Room temperature at the selected temperature until the next program period begins. The thermostat will then revert back to the
program temperatures.
Move the
SYSTEM
switch to the
OFF
position, then press and hold the
PRGM
and
RUN
buttons for 3 seconds to enter the
configuration menu. The display will show the first item in the configuration menu. Use the ▲or▼ buttons to adjust respective
values.Press the
PRGM
=next menu item, press
TIME
= previous menu item.
All settings will revert to factory default values by press the
RESET
hole
button, including program settings.
To exit the configuration menu and return to normal operation, press the
RUN
button.
If no buttons are pressed within 130 seconds, the thermostat will exit the configuration menu automatically.
The configuration menu chart summaries the configuration options. An explanation of each option follows.
Step
Press Buttons
Displayed (Defaults)
Select by ▲ or▼
Description
1
PRGM
and
RUN
3 seconds
CC (FA)
FA or SL
Select (FA)st or (SL)ow
cooling cycles,
Default = FA
-Note 1
2
PRGM
HC (FA)
FA or SL
Select F(ast) or (S)low Heating
cycles. Default = FA
-Note 1
Thermostat Operation
Configuration Menu
The configuration menu allows you to set certain thermostat operating characteristics to your system or personal
requirements. It is also called as ISU(Installation Set-Up) process.
