20 of 33
Service Manual UK
Indesit
Company
English
D. Control / Display Module Assembly
E. Door Seal
1. Remove the front Panel as in (G)
2. The seal can now be removed from the front panel.
Note: The seal is held in place by being compressed between the front air duct and front panel.
When re-fitting, fit the door seal to the front panel first, and then carefully locate the front panel in position
without disturbing the seal.
F.
Belt
1.
Remove Door assembly (C)
2.
Place the door assembly on a
protected flat surface.
3.
Remove the control module
cover 5 Torx T8 screws.
4.
Disconnect the edge connector.
5.
Release the 4 retaining lugs and
ease the control module away
from the door.
(The knobs, buttons etc. remain
fitted to the module.
Note
: When refitting the control module you are advised to fit the
edge connector before clipping into position.
1.
Remove the side panels as in (B).
2.
Remove the cooling impeller cover using a small
blade screwdriver to lift the cover locking tabs.
3.
Unclip & lift away the Motor Cover Top (see Fig 1)
4.
Unclip & lift away the Outer Motor Cover (see Fig 2)
5.
Remove the cooling impeller.
6.
Remove the rear bearing as in (K).
7.
Remove the heater unit as in (M).
8.
Remove the recirculating impeller.
9.
Remove the 3 hex head screws behind the
recirculating impeller securing the motor to rear of
the base moulding. This will release the belt
tension.
10. Rotate the motor towards the centre of the dryer to
disengage the belt from the jockey pulley.
11. Remove the 2 screws securing the rear panel to the
side strut.
12. Remove the 2 screws securing the water container
housing to the rear panel.
13. Remove the hose spigot from the container housing
by rotating 90°.
14. Pull the rear panel backward to disengage the drum
shaft from the drum rear panel and slide the belt
back to remove from the drum.
15. Replace in reverse order. When refitting the belt
first position the belt over the jockey wheel, refit as
in (O).
Fig 1
Unclip
and lift
clear
Fig 2
Release
clip and
lift away