9 of 33
Indesit
Company
Service Manual UK
English
Progress and Warning Lamps
ECO Led
The Eco LED will illuminate when the user adjusts the knob/option settings, which involve an
energy reduction, from the default settings.
Auto Cycles - If the sensing level is reduced. (Hanger, iron or damp dry)
Timed Cycles - If the time is adjusted to 120 minutes or lower.
Child Lock (Button)
To enable the Child Lock function, press and hold the "Child Lock" button until the Button Led
illuminates. All the controls on the dryer are now disabled.
If the selector is turned or an Option is pressed the Child Lock button will flash and the machine will
bleep, to remind the customer that the Child Lock is active.
To remove the controls child lock, press and hold the child lock button and until the button lamp
goes out.
Drying Led
Is illuminated when the machine is drying.
Cool Tumble
Is illuminated, when the dryer is on a cycle, and the heater element is off, this would be the
cool down period at the end of the cycle.
End
Is illuminated when the programme has finished its cycle.
Empty Water/ Clean Filter
Is illuminated (permanently "on"), at the end of every cycle as a reminder to the customer to
empty the water container and to clean the filter after every use.
If the Empty Water / Clean Filter Led illuminates during a cycle, (H2) would also be shown in
the display. The machine has sensed the water container is full, after approximately
1 minute the heater is turned off and continues for 10 minutes with cool air only, before
displaying the fault (H2) and LED. To continue the cycle, empty the container, push the
Start/Pause button and the machine will continue.
Clean Condenser
Is illuminated every 25 cycles to remind the customer the condenser should be regularly
removed and cleaned. The Clean Condenser Warning is only a reminder and is not
connected to any sensing device-It does not indicate the condition of the condenser.