18
GB
Instructions for the fitter
Mounting the wooden panel onto the door and
inserting the machine into cabinets:
In the case where the machine must be shipped for final
installation after the wooden panel has been mounted, we
suggest leaving it in its original packaging. The packaging
was designed to make it possible to mount the wooden
panel onto the machine without removing it completely
(see figures below).
The wooden panel that covers the face of the machine
must not be less than
18 mm
in thickness and can be
hinged on either the right or left. For the sake of
practicality when using the machine, we recommend that
the panel be hinged on the same side as the door for the
machine itself - the left.
A
B
C
D
E
Tur s
eite
Door Mounting Accessories
(Fig. 1-2-3-4-5).
Fig. 1
N° 2 Hinges
N° 1 Magnet
N° 1 Magnet plate
N° 1 Rubber plug
N° 2 Hinge Supports
N° 1 Spacer
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 4/B
- No. 6 type
A
self-threading screws, l =13 mm.
- No. 2 type
B
metric, countersunk screws, l =25; for
fastening the magnet plate to the cabinet.
- No. 4 type
C
metric screws, l =15 mm; for mounting the
hinge supports to the cabinet.
- No. 4 type
D
metric screws, l =7 mm; for mounting the
hinges on the supports.
Mounting the Parts onto the Face of the Machine.
- Mount the hinge supports onto the face of the machine,
positioning the hole indicated by the arrow in
fig. 1
towards
the inside of the face and using the type
C
screws.
- Mount the magnetic plate on the opposite side, at the
top, using the two type
B
screws.
- Place the spacer illustrated in
fig. 4/B
between the
appliance front and the magnet receiver.
