2
8
GB
S
w
itchin
g
the
appliance
off
Disconnect your appliance from the electricity
supply before carrying out any work on it.
C
l
ea
ning
t
h
e
a
pp
li
a
n
c
e
Never use steam cleaners or pressure cleaners on
the appliance.
The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge which has been soaked in lukewarm
water and neutral soap. Use specialised products
for the removal of stubborn stains. After cleaning,
rinse well and dry thoroughly. Do not use abrasive
powders or corrosive substances.
The hob grids, burner caps, flame spreader rings
and burners may be removed to make cleaning
easier; wash them in hot water and non-abrasive
detergent, making sure all burnt-on residue is
removed before drying them thoroughly.
Clean the terminal part of the flame failure safety
devices* frequently.
The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product,
then dry thoroughly with a soft cloth. Do not use
rough abrasive material or sharp metal scrapers
as these could scratch the surface and cause the
glass to crack.
The accessories can be washed like everyday
crockery, and are even dishwasher safe.
Do not close the cover when the burners are alight
or when they are still hot.
I
nspecting
the
o
v
en
seals
Check the door seals around the oven regularly. If
the seals are damaged, please contact your nearest
Authorised After-sales Service Centre. We
recommend that the oven is not used until the seals
have been replaced.
R
e
p
l
a
c
ing
t
h
e
o
v
e
n
lig
h
t
b
u
l
b
1. After disconnecting the
oven from the electricity
mains, remove the glass lid
covering the lamp socket (
see
figure
).
2. Unscrew the light bulb and
replace it with a similar one:
voltage 230 V, wattage 25 W,
cap E 14.
3. Replace the lid and reconnect the oven to the
electricity supply.
G
a
s
ta
p m
a
in
te
n
a
n
c
e
Over time, the valves may become jammed or
difficult to turn. If this occurs, the valve must be
replaced.
This
procedure
must
be
performed
by
a
qualified
technician
w
ho
has
been
authorised
by
the
manufacturer
.
Assis
ta
n
c
e
W
a
r
ning
:
The appliance is fitted with an automatic diagnostic
system which detects any malfunctions.
Malfunctions are displayed by messages of the
following type: F followed by numbers.
Call for technical assistance in the event of a
malfunction.
Never use the services of an unauthorised
technician.
Please
ha
v
e
the
follo
w
ing
information
to
hand
:
The type of problem encountered.
The appliance model (Mod.).
The serial number (S/N).
The latter two pieces of information can be found on
the data plate located on the appliance.
Ca
r
e
an
d
m
aintenan
c
e
*
Only
available
in
certain
models
.
