GB
3
Connecting the drain hose
Connect the drain
hose, without bending
it, to a drain duct or
a wall drain situated
between 65 and 100
cm from the floor;
alternatively, placed
it over the edge of a
basin, sink or tub, fa-
stening the duct sup-
plied to the tap (
see
figure
). The free end
of the hose should
not be underwater.
!
We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose
and must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electri-
city socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maxi
-
mum power load of the appliance as indicated
in the Technical data table
(see opposite);
• the power supply voltage falls within the va
-
lues indicated in the Technical data table (
see
opposite
);
• the socket is compatible with the plug of the
washer-dryer. If this is not the case, replace
the socket or the plug.
!
The washer-dryer must not be installed ou-
tdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
!
When the washer-dryer has been installed,
the electricity socket must remain within easy
reach.
!
Do not use extension cords or multiple sockets.
!
The cable should not be bent or compressed.
!
The power supply cable must only be repla-
ced by authorised technicians.
65 - 100 cm
Warning! The company shall not be held
responsible in the event that these standards
are not observed.
The first wash cycle
Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using
wash cycle number auto clean
(see “Cleaning
the washer-dryer”).
Technical data
Model
FDD 9640
Dimensions
width 59.5 cm
height 85 cm
depth 54 cm
Capacity
from 1 to 9 kg for the wash
programme
from 1 to 6 kg for the drying
programme
Electrical
connections
please refer to the technical
data plate fixed to the machine
Water con-
nections
maximum pressure 1 MPa
(10 bar)
minimum pressure 0.05 MPa
(0.5 bar)
drum capacity 58 litres
Spin speed
up to 1400 rotations per
minute
Energy ra-
ted
programmes
according to
regulation
EN 50229
Wash
: programme 2; tempe-
rature 60°C (
2st press of the
button)
; using a load of 9 kg.
Drying
: the smaller load
(3kg) must be dried by se-
lecting the “EXTRA” dryness
level. The load must consist
of 3 sheets, 2 pillowcases
and 1 hand towel;
the remainder of the load
must be dried by selecting
the “EXTRA” dryness level.
This appliance conforms to
the following EC Directives:
- 2004/108/EC (Electroma-
gnetic Compatibility)
- 2006/95/EC (Low Voltage)
- 2012/19/EU (WEEE)
Summary of Contents for FDD 9640
