3
GB
Technical data
Model
RDSG 86207
Dimensions
width 59.5 cm
height 85 cm
depth 54 cm
Capacity
from 1 to 8 kg for the wash
programme
from 1 to 6 kg for the drying
programme
Electrical
connections
please refer to the technical
data plate fixed to the machine
Water con-
nections
maximum pressure
1 MPa (10 bar)
minimum pressure
0.05 MPa (0.5 bar)
drum capacity 58 litres
Spin speed
up to 1200 rotations per
minute
Energy ra-
ted
programmes
according to
regulation
EN 50229
Wash
: programme 8; tem-
perature 60°C; using a load
of 8 kg.
Drying
: select the 8 wash
programme and set the
drying level to “A3”, for both
loads. The first drying cycle
must be carried out with the
nominal load
This appliance conforms to
the following EC Directives:
- EMC 2014/30/EU (Electro-
magnetic Compatibility)
- LVD 2014/35/EU (Low
Voltage)
- 2012/19/EU (WEEE)
Connecting the drain hose
Connect the drain
hose, without bending
it, to a drain duct or
a wall drain situated
between 65 and 100
cm from the floor.
Alternatively, place
the drain hose
over the edge of
a washbasin or
bathtub, by fastening
the guide
(which
can be purchased
at the technical
assistance centre) to
the tap (
see figure
).
The free end of the
hose should not be underwater.
!
We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose
and must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the
electricity socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the
maximum power load of the appliance as
indicated in the Technical data table
(see
opposite);
• the power supply voltage falls within the
values indicated in the Technical data table
(
see opposite
);
• the socket is compatible with the plug of
the washing machine. If this is not the case,
replace the socket or the plug.
!
The washing machine must not be installed
outdoors, even in covered areas. It is
extremely dangerous to leave the appliance
exposed to rain, storms and other weather
conditions.
!
When the washing machine has been
installed, the electricity socket must remain
within easy reach.
65 - 100 cm
!
Do not use extension cords or multiple sockets.
!
The cable should not be bent or compressed.
!
The power supply cable must only be
replaced by authorised technicians.
Warning! The company shall not be held
responsible in the event that these standards
are not observed.
The first wash cycle
Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using
wash cycle auto clean
(see “Cleaning the
washing machine”).
