24 of 35
Service Manual UK
Indesit
Company
English
PROGRAMMING (Using EMIT)
These dishwashers can be programmed via the Emit, using a USB lead (Part number C00222800),
Hardware key (Part number C00115587) & the Memwriter software.
You MUST hold the Reader in place whilst programming is taking place
.
PROGRAMMING (Using Smartcard Reader / Card)
If the Main Module has been replaced during a repair the module will require programming using
the following method.
1.
Select Memwriter programme.
2.
Ensure correct Valid Comport is selected.
3.
Ensure correct Hardware key is selected (Black).
4.
Ensure correct Appliance type is selected (New Platform)
5.
Select Commercial Code.
6.
Open Comm Port (A bright green connection icon will light
on screen).
7.
Click into CODE BOX in "Search Method".
8.
Insert Commercial Code & Serial number.
9.
Click search button.
10. File to download box's will now display machine
information.
11. Click download.
If appliance already has the most upto date file a warning
box will appear indicating EEPROM ALREADY UPDATED
NOTE: When starting Memwriter programme the default
selection is always GET FROM HARDWARE.
Black Hardware Key
USB - Serial Cable
A Hardware Key Pin Repair Kit is
available which contains
5 replacement pins
(order Part No. C00114723).
1.
Do NOT connect the machine to electrical supply
.
2.
Insert the pre-programmed card into the Card reader.
Care must be taken at this point to ensure the card is
inserted correctly with the Chip on the card facing the
PCB of the Reader.
3.
Insert the Reader & Card into module connection port
- see photo. You MUST hold the Reader in place
whilst programming is taking place.
4.
Connect the machine to the Electrical supply
, the
LED's on the Smart Card Reader will light in this
sequence:
a)
Red OFF: Good Communication between Smart Card
Reader & Card.
b)
Red OFF; Green Blinking: Download taking place.
c)
At end, Green ON ---> Download OK.
d)
At end, Red ON ---> Download NOT OK.
5. Programming Complete, disconnect the machine from
Electrical supply.
6. Remove the Smart Card Reader.
Smart Card Reader
and Smart Card in use
You MUST hold the Reader in place whilst
programming is taking place.
