EN - 11
4.8. Filling the detergent
Push the latch to open the dispenser and
pour in the detergent.
Close the lid and press it until it locks in
place. The dispenser should be refilled just
before the start of each programme. If the
dishes are heavily soiled, place additional
detergent in the pre-wash detergent
chamber.
DETER
GENT
4.9. Using combined detergents
These products should be used according
to the manufacturer’s instructions.
Never put combined detergents into the
interior section or the cutlery basket.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the combination.
We recommend you do not use combined
detergents in short programmes.
Please use powder detergents in such
programmes.
If you encounter problems when using
combined detergents, please contact the
detergent manufacturer.
When you stop using combined detergents,
make sure that water hardness and rinse
aid settings are set to correct level.
4.10. Rinse-aid usage
Rinse-aid makes dishes sparkle and helps
them to dry without spotting. Rinse-aid is
required for stain-free utensils and clear
glasses. Use only rinse-aid for domestic
dishwashers.
4.11. Filling the rinse-aid and setting
To fill the rinse aid compartment, remove
the rinse-aid compartment cap by turning it.
Fill the compartment with rinse aid until the
level indicator goes dark. Replace the cap
and close it by turning it. Be careful not to
overfill the rinse aid compartment and wipe
up any spills.
The rinse-aid compartment has a level
adjuster, numbered 1 to 6, which controls
how much rinse aid is used in each wash.
The factory setting is “3”.
If the dishes are not drying properly or are
spotted, increase the level. If blue stains
form on your dishes, decrease level. To do
this, remove the cap and rotate the indicator
arrow setting then replace the cap.
