Hotpoint Aquarius DWF40, Instructions For Installation And Use Manual

8 

ARISTON DISHWASHER - Instructions for installation and use

D

ISHWASHER

First of all.
- Turn on the water supply
tap completely.
- Add the correct amount of
detergent.
- Load the baskets correctly.
- Check that the spray arms
rotate freely.
- Close the door securely.

- Press the ON-OFF button "A":
you will hear a short beep and indi-
cator light "B" comes on.
Your appliance is now on and await-
ing instructions.

Select the wash cycle.
Select the wash cycle by turning
knob "D" clockwise until the indica-
tor is in line with the letter of the wash
cycle required.
Select the wash cycle most suitable
for the type of dishes to wash (see
‘Programme  Chart’).
After a few seconds you will hear a
short beep and indicator light “G”
will come on, indicating the wash
cycle has begun. It is not advisable
to make any changes at this point.

Indicator lights.
Your dishwasher has indicator lights
"G" which light up to indicate the
wash cycle phase that is underway.

Modifying a wash cycle in
progress.
If you have chosen the wrong cycle
- You can modify the wash cycle in
progress, if it has only just started.
Turn the knob anti-clockwise and
set it to Reset, after a few seconds
you will hear four beeps and indica-
tor light "G" will go out to show all the
settings will have been cancelled.
You are now free to re-set the cor-
rect wash cycle.

You've left out a dish?
Interrupt the wash cycle by press-
ing the On-Off button  "A",  then
insert the dish you had forgotten.
When you shut the door, press the
On-Off button again. The cycle will
start up from where you interrupted
it.

Cycle end
The end of the wash cycle is indi-
cated by 2 short beeps and  the
flashing  of the drying phase indica-
tor light.
Turn the appliance off by pressing
the On-Off button “A”, thus switch-
ing off the electricity supply.
Turn off the water tap.
Wait a few minutes before unload-
ing the dishes: they are very hot! If
you wait a little while, they dry better
due  to the steam.
Empty the lower basket first.

There's been a power
failure or you opened the
dishwasher door
The wash cycle stops and then
restarts when the electricity comes
back on or when you close the door.

For your own safety,
ensure the door is closed,
when the dishwasher is
not in use.

How to use your Dishwasher