Hotpoint BCI45, Instructions For Installation And Use Manual

7

D

ISHWASHER

First of all.
- Turn on the water supply
tap completely.
- Add the correct amount of
detergent.
- Load the baskets correctly.
- Check that the spray arms
rotate freely.
- Close the door securely.

- Press the ON-OFF button "A":
indicator light "B" comes on. Your
appliance is now on and awaiting
instructions.

Select the wash cycle.
Select the wash cycle by pressing
button "P". Each time this button is
pressed, one of the indicator lights
"M" will come on in sequence, se-
lect the wash cycle most suitable
for the type of dishes to wash (see
‘Programme  Chart’).
Close the door and after a few sec-
onds, you will hear a short beep: the
wash cycle has begun.

Modifying a wash cycle in
progress.
If you have chosen the wrong cycle
- You can modify the wash cycle in
progress, if it has only just started.
Open the appliance door carefully
to avoid any hot water splashes,
then keep button "P" pressed for
approximately 5 seconds, until you
hear 3 short beeps. Indicator light
"M" will come off and at this point, all
the settings will have been cancelled.
You are now free to re-set the cor-
rect wash cycle.

You've left out a dish?
Interrupt the wash cycle by opening
the appliance door with the utmost
care, as usual, then insert the dish
you had forgotten. When you shut
the appliance door, the cycle will
start up from where you interrupted
it.

Cycle end
The end of the wash cycle is indi-
cated by a double beep and the flash-
ing of the wash cycle indicator light
"M".
Open the dishwasher door, press
the ON-OFF button cutting off the
electricity supply to the appliance.
Turn off the water tap.

Wait a few minutes before unload-
ing the dishes: they are very hot! If
you wait a little while, they dry better
due  to the steam.
Empty the lower rack first.

There's been a power
failure or you opened the
dishwasher door
The wash cycle stops and then
restarts when the electricity comes
back on or when you close the door.

How to use your Dishwasher