Hotpoint CF1A 100 H UK, Installation Instructions Manual

3

OPERATING YOUR FREEZER

1

2

3

4

1.Power LED

2.Running LED

3.Alarm

4.Thermostat knob

Plug replacement(UK&lreland only)

 Should you need to replace the plug,the 
wires in the power cable are colour in the 
following way:
 Blue - Neutral ’N’
 Brown - Live ‘L’
 Green&Yellow - Earth ‘E’
 As the colours of the wires in the power cable 
may not correspond with the coloured 
markings identifying the terminals in your 
plug,and proceed as follows:
 The green&yellow wire must be connected to 
the terminal in the plug that is marked with 
the letter E or by the earth symbol.
 The blue wire must be connected to the 
terminal that is marked with the letter N.
 The brown wire must be connected to the 
terminal that is marked with the letter L.
 If power supply cord is damaged,it must 
replaced by the manufacturer or its service 
agent or a similar qualified person in order to 
avoid a hazard.

Replacing the light bulb

To replace the light bulb, pull out
the plug from the electrical socket. 
Follow the instructions below.
Access the light bulb by removing the 
cover as indicated in the
diagram. Replace it with a similar light 
bulb within the power range
indicated on the cover (10W).

Temperature Control

 The range of the temperature control is from
position" Min" the warmest to "Max" the 
coldest.Adjust the temperature control to the 
setting that best suits your needs. The setting 
of medium position should be appropriate for 
home or office freezer use.

NOTE:

 Turning the temperature control to "OFF" 
position stops the cooling cycle but does not 
shut off the power to the freezer.
 If the unit is unplugged, lost power, or turned 
off; you must wait 3 to 5 minutes before 
 Restarting  the  unit. If you attempt to restart 
before this time delay, the freezer will not 
start.
 Large amounts of food will lower the cooling 
efficiency of the appliance.
 If you choose to change the thermostat 
setting, adjust thermostat control by one 
numerical increment at a time.  Allow several 
hours for temperature to stabilize between 
adjustments.