background image

INSTRUCTIONS FOR USE

GB

DIAGRAM OF THE APPLIANCE (Fig. 1)

A. 

Handle.

B. 

Safety lock (if provided).

C. 

Gasket.

D. 

Separator (if provided).

E. 

Defrost water drain plug.

F. 

Control panel.

G. 

Side motor cooling grille.

INSTALLATION

• 

Unpack the appliance.

• 

Remove the 4 spacers inserted between the door 

and the appliance. (Fig. 3)

•  Make sure the defrost water drain plug (if provided) is 

correctly positioned (E).

•  For optimum appliance operation and to avoid damage 

when the door is opened, leave a space of at least 7 cm 

from the rear wall and 7 cm at the sides. 

(Fig. 4)

•  Fit the accessories (if provided).

•  Clean the inside of the appliance before using it.

DIAGRAM OF THE CONTROL PANEL (Fig. 2)

a. Red LED:

 when flashing, it indicates that an alarm 

condition is present see TROUBLESHOOTING GUIDE.

b. Green LEDs: 

they indicate that the appliance is in 

operation, and the temperature has been set as follows:

b1 

less cold temperature (right light on), use this setting 

with partial loads will optimise energy consumption.

b2 

middle temperature (centre light on)

b3 

very cold temperature (left light on)

ALL Green LEDs ON: 

FAST FREEZING function is active; 

see the section “freezing fresh food”.

c. Temperature setting button:

 to adjust the set 

temperature and to activate/deactivate the fast freezing 

operations.

To select the desired temperature, repeatedly press the 

setting button (3): each time the button is pressed, the set 

temperature is updated.

To activate/deactivate fast freezing function, pressing 

for approximately 3 seconds: all green LEDs flash 

simultaneously 3 times and then remain lit.

Note: 

The settings will be saved in the memory even if 

a power cut occurs. The time needed for the temperature 

inside the freezer to reach the set value, can vary 

depending on climatic conditions and the set temperature 

itself.

SWITCHING ON THE APPLIANCE

•  Plug in the appliance.

•  The green LED lights up (middle temperature).

• 

The red LED flashes to indicate that the temperature 

inside the appliance is not yet sufficiently low for food 

storage. The red LED will normally switch off within the 

first six hours after the appliance is switched on.

•  Place food inside the product only when the red LED has 

switched off.

Note: 

As the seal is tight, the appliance lid cannot be 

reopened immediately after closing. Wait a few minutes 

before re-opening the lid of the appliance.

This appliance features “skin condenser” technology: 

the condensing unit is integrated into the walls of 

the freezer. For this reason the side and front walls 

of the product may become hot while the product 

is running. This is entirely normal and also reduces 

the risk of condensation forming in particularly 

critical environmental conditions (see paragraph 

“Troubleshooting guide”).

FREEZING FOOD

Preparation of fresh food for freezing

•  Before freezing, wrap and seal fresh food in: aluminium 

foil, cling film, air and water-tight plastic bags, 

polyethylene containers with lids, provided they are 

suitable for freezing foods.

•  Food must be fresh, mature and of prime quality in order 

to obtain high quality frozen food.

•  Fresh vegetables and fruit should preferably be frozen 

as soon as they are picked to maintain the full original 

nutritional value, consistency, colour and flavour.

•  Always leave hot food to cool before placing in the 

appliance.

Freezing fresh food

•  Place foods to be frozen in direct contact with the walls 

of appliance: 

A)

 - foods to be frozen, 

B)

 - foods already frozen.

•  Avoid placing foods to be frozen in direct contact with 

food already frozen.

•  For best and fastest freezing, foods should be split into 

small portions; this will also be useful when the frozen 

items are to be used.

1. 

At least 24 hours before storing fresh foods inside the 

product for freezing, activate the fast freezing function by 

pressing button 

c

 for approximately 3 seconds. All green 

LEDs (

b

) comes on.

2. 

Introduce the food to freeze inside the appliance, and 

keep the door of the appliance closed for 24 hours. 

After this period the food will be frozen. The fast freezing 

function can be deactivated pressing button 

c

 for 

approximately 3 seconds. 

If the fast freeze function is not manually deactivated, it 

will be automatically deactivated by the appliance after 

50 hours.

FOOD STORAGE

Refer to the table on the appliance.

Classification of frozen foods

Load and classify the frozen foods; it is advisable to indicate 

the storage date on the packs, to ensure consumption 

before the expiry dates listed in months in 

fig. 6

 for each 

type of food.

Advice for storing frozen food

When buying frozen food, make sure that:

•  The packaging is intact (food in damaged containers 

may have deteriorated). If a package is swollen or has 

damp patches, the product may not have been stored 

in optimum conditions and therefore undergone partial 

defrosting.

•  When shopping, leave frozen food purchases until last 

Reviews: