GB
26
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
If something
goes wrong...
$
Oven light does not
work
The oven lamp is not covered by the guarantee. The part is easily changed (see the section
on oven lamp replacement). A new lamp may be obtained from our Parts department see
back page.
Draught from
beneath control
panel
A gentle flow of air will be blown from beneath the control panel when the appliance is
used. If the appliance is still warm, this cooling fan may run on, or restart itself when all
controls have been turned off. The fan will stop once the appliance has been cooled. This
is normal and not a fault.
Steam /
Condensation in
the oven after use.
Steam is a by - product of cooking any food with a high water content. To help minimise
always:
a) Try to avoid leaving food in the oven to cool after being cooked.
b) Use a covered container, wherever possible.
If you have been through the above list and there is still a problem, contact Service (see back page).
Disposal of your product
To minimise the risk of injury to children please
dispose of your product carefully and safely.
Remove all doors and lids. Remove the mains cable
(where fitted) by cutting off flush with the appliance
and always ensure that no plug is left in a condition
where it could be connected to the electricity
supply.
To help the environment, Local Authority instructions
should be followed for the disposal of your product.
Disposal of old electrical appliances
The European Directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances
must not be disposed of in the normal unsorted
municipal waste stream. Old appliances must be
collected separately in order to optimise the
recovery and recycling of the materials they contain
and reduce the impact on human health and the
environment.
The crossed out "wheeled bin" symbol on the
product reminds you of your obligation, that when
you dispose of the appliance it must be separately
collected.
Consumers should contact their local authority or
retailer for information concerning the correct
disposal of their old appliance.
Problem
Possible cause
Solution
The appliance has just been
connected to the electricity
mains or there has been a blackou
Set the clock.
A programmed cooking mode
does not start.
There has been a blackout.
Reprogram the cooking mode.
Only the high luminosity
“Clock button” is lit.
The appliance is in standby mode Press any button to exit
standby mode.
An automatic mode has been
selected. “Hot” appears on the
display and cooking does not start
The temperature inside the oven
is higher than the suggested value
for the selected mode.
Wait for the oven to cool down.
Fan-assisted cooking has been
selected and the food looks burnt.
Positions 1 and 5: the direct
heat could cause
temperature-sensitive
foods to burn.
We recommend switching
dripping pan positions halfway
through cooking.
The “Clock button” and the
digits on the display flash.
