Hotpoint FB 51 A.1 IX/HA, Operating Instructions Manual

13

GB

Electrical connections

!

 Ovens equipped with a three-pole power supply

cable are designed to operate with alternating
current at the voltage and frequency indicated on
the data plate located on the appliance (

see below).

Fitting the power supply cable

1. Open the terminal
board by inserting a
screwdriver into the
side tabs of the cover.
Use the screwdriver as
a lever by pushing it
down to open the cover
(

see diagram).

2. Loosen the cable
clamp screw and
remove it, using a
screwdriver as a lever
(see figure).

3. Remove the wire
contact screws L-N- 
, then fasten the wires
under the screw heads,
respecting the colour
code: Blue (N), Brown
(L) and Yellow-Green
Verde (

).

Connecting the supply cable to the mains

Install a standardised plug corresponding to the
load indicated on the data plate (

see side).

The appliance must be directly connected to the
mains using an omnipolar circuit-breaker with a
minimum contact opening of 3 mm installed between
the appliance and the mains, suitable for the load
indicated and complying with current electrical
regulations (the earthing wire must not be interrupted
by the circuit-breaker). The supply cable must not
come into contact with surfaces with temperatures
higher than 50°C.

!

 The installer must ensure that the correct electrical

connection has been made and that it is compliant
with safety regulations.

Before connecting to the power supply, make sure
that:
• The appliance is earthed and the plug is

compliant with the law.

• The socket can withstand the maximum power of

the appliance, which is indicated on the data
plate (

see below).

• The voltage must be in the range between the

values indicated on the data plate (

see below).

• The socket is compatible with the plug of the

appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it. Do
not use extension cords or multiple sockets.

!

 Once the appliance has been installed, the power

supply cable and the electrical socket must be easily
accessible.

!

 The cable must not be bent or compressed.

!

 The cable must be checked regularly and replaced

by authorised technicians only (

see Assistance).

! The manufacturer declines any liability should
these safety measures not be observed.

DATA PLATE 

Dimensions 

width cm 43.5 

height cm 32 

depth cm 40 

Volume 

lt. 56 

Electrical 

connections 

voltage: 230V ~ 50/60Hz o 50Hz  (see 

data plate) maximum power 

absorbed 2250W 

ENERGY LABEL 

Directive 2002/40/EC on the label of 

electric ovens Norm EN 50304 

Models with cooling ventilation: 

Energy consumption for Natural 

convection heating mode:  

a

 Convection 

Declared energy consumption for 

Forced convection Class  

heating mode: 

b

 Fan assisted 

Models without cooling ventilation: 

Energy consumption for Forced 

convection heating mode:  

b

 Fan assisted 

Declared energy consumption for 

Natural convection Class heating 

mode: 

a

 Convection 

This appliance conforms to the 

following European Economic 

Community directives:  

- 2006/95/EEC of 12/12/06 (Low 

Voltage) and subsequent 

amendments; 

-2004/108/EEC of 15/12/04 

(Electromagnetic Compatibility) and 

subsequent amendments; 

- 93/68/EEC of 22/07/93 and 

subsequent amendments - 

2002/96/EC and subsequent 

amendments.