Hotpoint FZS150G, Operating Instructions Manual

GB

3

Reversible door

1

2

3

4

5

Disposing of the plug

Cut off and dispose of the supplied plug if it does not fit
your socket. The cable should be cut as close as
possible to the moulded plug.
Remove the fuse.

WARNING:

To avoid a shock hazard do not insert the discarded
plug into a socket anywhere else.

Fitting a new plug

IMPORTANT:

WIRES IN THE MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE...

Green and Yellow

- Earth

Blue

- Neutral

Brown

- Live

As the colours of the wires in the mains lead may not
correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
-

Connect Green and Yellow wire to terminal marked
'E' or 

  or coloured Green and Yellow.

-

Connect Brown wire to terminal marked 'L' or
coloured red or brown.

-

Connect Blue wire to terminal marked 'N'  or
coloured Black or Blue.

If a 13amp plug (BS 1363) is used it must be
fitted with a 13amp fuse.  A 15amp plug must be
protected by a 15amp fuse, either in the plug or adaptor
or at the distribution board.

If you are in any doubt about the electrical
supply to your machine, consult a qualified
electrician before use.

CE Marking certifies that this appliance conforms to
the following EEC directives :
Low Voltage Equipment - 73/23/EEC & 93/68 EEC
Electromagnetic Compatibility 89/336/EEC, 92/31/EEC
& 93/68/EEC