background image

4

OPTIONS AND FUNCTIONS

OPTIONS can be selected directly by pressing the corresponding button 

(see CONTROL PANEL)

.

If an option is not compatible with the selected program 

see PROGRAMS TABLE

, the corresponding LED fl ashes rapidly 3 times 

and beeps will sound. The option will not be enabled.

TABLET (Tab)

This setting allows you to optimize the performance of the 
program according to the type of detergent used.

Press the TABLET button (the indicator light will light up) if you 
use combined detergents in tablet form (rinse aid, salt and 
detergent in 1 dose).

If you use powder or liquid detergent, this option should 
be off .

DELAY

It is possible to delay the start time of the program by 

2

4

or 

8

 hours:

1.  After selecting the desired program and any other options, 

press the DELAY button. The indicator light will go on.

2.  Select the desired delay time by pressing the DELAY button 

repeatedly. The 2 hours, 4 hours and 8 hours indicator lights 
will go on in succession. If the DELAY button is pressed 
again, the option is deselected and the indicator light 
goes off;

3.  After the selection process, the countdown will begin if the 

START/PAUSE button is pressed. The selected delayperiod 
indicator light is on and the START/Pause button lights up 
(fixed light).

4.  Once this time has elapsed, the DELAY indicator light goes 

off and the program begins. 

The DELAY function cannot be set once a program has 
been started.

DRAIN OUT

To stop and cancel the active cycle, the Drain Out function 
can be used.
A long press of START/Pause button, will activate the DRAIN 
OUT function. The active program will be stopped and the 
water in the dishwasher will be drained out.

Summary of Contents for HSFE1B19SUKN









Reviews: