GB
23
Care and Cleaning
Cleaning the glass doors
DROP DOWN DOORS
Open the door fully and
carefully slide the first
inner glass towards you,
taking care not to allow
the glass to fall.
If necessary, the glass
can be pushed delicately
from the back side.
Repeat the same
procedure with the next
glass.
Now the external glass
panel can be washed.
WARNING! As soon as the inner and middle glass
panels are removed , the door slams shut.
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop
down doors.
Open the lower door
and lift out the inner
door glass
Remove the two
rubber anti-rattle
bungs
Remove the centre
glass taking care to
support the weight of
the glass when
removing and fitting
The glass panels may now be washed at the sink.
Stubborn stains can be removed by using a fine
steel wool soap pad.
Replace in the reverse order.
Ensure anti-rattle bungs are fitted before fitting inner
door glass.
BE CAREFUL NOT TO DAMAGE THE GLASS
PANELS BY PUSHING THEM TOO HARD.
When fitting the glass make sure it is fitted correctly
ie reflective face is fitted the right way round.
Ensure the glass panel is not subjected to any sharp
mechanical blows. Take particular care not to
damage the inner surface which is coated with a heat
reflective layer. After cleaning, rinse and dry with a
soft cloth. For slight soiling the inner glass panel may
be cleaned, while still warm, without removing it from
the door
Warning: Oven must not be operated with inner door
glass removed.
Anti- rattle bung
The door glass is
equipped with anti-rattle
bungs which prevents
rattling of the glass when
opening and shutting the
oven main door. These
can be removed for
washing.
WARNING : Be careful not to lose the bungs when
cleaning
Door and Control Panel (Glass)
Regularly wipe with a clean, damp cloth and polish
with a clean, dry cloth.
Door and Control Panel Trims (Stainless Steel)
Regularly wipe with a clean, damp cloth and polish
with a clean, dry cloth.
Replacement of the Oven Light
WARNING: Ensure that the appliance is switched
off before replacing the lamp to avoid the
possibility of electric shock.
Unscrew the glass cover, using a suitable cloth to
protect the fingers and remove carefully. Unscrew the
existing light bulb, and remove. Screw the new bulb
into position and replace the glass cover, with metal
washer, until positioned securely.
