14 of 49
Service Manual UK
Indesit
Company
English
USING THE OVEN
(Taken from user handbook)
The first time you use your appliance, heat the empty oven with its door closed at its maximum
temperature for at least half an hour. Ensure that the room is well ventilated before switching the oven
off and opening the oven door. The appliance may emit a slightly unpleasant odour caused by
protective substances used during the manufacturing process burning away.
Turn the control dial to adjust the parameter shown on the display between the "<" and ">" symbols.
To make the setting process easier, keep the control dial in position: this will increase the scrolling
speed of the numbers on the display.
Each setting will automatically be stored in the appliance memory after 10 seconds.
The touch controls cannot be activated if the user is wearing gloves.
Some models are equipped with a system of hinges which allows the door to close slowly, without the
user having to follow the movement through with his/her hand. To use the system correctly, before
closing the door:
•
Open the door fully.
•
Do not force the closing movement manually.
The shelves may have safety stops fitted to stop them from being pulled out too far when attending to
food. The shelves can be removed by simply lifting them slightly up from the front and sliding out.
The oven shelves may have a back stop, when inserting the shelf, make sure that the back stop is at
the rear of the cavity.
Switching the Oven on for the First Time
After connecting the oven to the electricity supply, the first time it is switched on the user should also
switch on the control panel by pressing the
button. The list of languages will appear in the menu. To
choose the desired language, select it using the control dial. Confirm by pressing the
icon.
Once the selection has been made, the display will show the settings menu. Press the
icon or
scroll through using the control dial until you reach the EXIT command and press the
icon to begin
using the oven.
After choosing the language in the menu, if the display is not used for another 30 seconds it will
automatically revert to programming mode.
