48 of 49
Service Manual UK
Indesit
Company
English
PROGRAMMING
PROGRAMMING (using Smart Card Reader / Card C00272306)
If the Main Module has been replaced during a repair the
board will require programming using the following method.
1.
Do NOT connect the machine to electrical supply.
2.
Insert the pre-programmed card into the Card reader.
Care must be taken at this point to ensure the card is
inserted correctly with the Chip on the card facing the
PCB of the Reader.
3.
Insert the Reader and Card into module connection port
- see photo.
4.
Connect the machine to the Electrical supply
, the LEDs
on the Smart Card Reader will light in this sequence:
a)
Red
ON: Good Communication between Smart
Card Reader and Card.
b)
Red
OFF;
Green
Blinking: Download taking place.
c)
At end,
Green
ON ---> Download OK.
d)
At end, Red ON ---> Download NOT OK.
5.
Programming Complete, disconnect the machine from
Electrical supply.
6.
Remove the Smart Card Reader.
NOTES
a
If the
Red
LED is flashing SLOWLY, and a smart card is inserted, check for the following:
•
Blank/erased smart card (previously used),
•
Incorrectly inserted smart card (check orientation of smartcard chip).
b
If the
Red
LED is flashing RAPIDLY, check for the following:
•
Ensure a smart card has been inserted into the smart card reader,
•
Ensure the smart card has been fully inserted?
Smart Card in use
Smart Card Reader and
