22
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Care and Cleaning
Take particular care not to damage the inner
surface of the door inner glass that is coated with
a heat reflective layer. Do not use scouring pads,
or abrasive powder, which will scratch the glass.
Ensure that the glass panel is not subjected to any
sharp mechanical blows.
Stubborn stains can be removed by using a fine steel
wool pad. For slight soiling the inner glass panel may
be cleaned, while still warm, without removing it from
the door. After cleaning, rinse and dry with a soft cloth.
CLEANING THE DOORS
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop
down doors, except take care to support the weight
of the inner glass when removing and refitting.
DROP DOWN DOORS
Remove the door inner glass as follows.
1. Open the door fully and unscrew the two screws
securing the glass panel so that the securing bra-
ckets can be turned. There is no need to remove
the screws completely.
2. Turn the brackets so that the glass can be removed
and cleaned at the sink
(Fig. 1.).
3. The inside of the outer
door glass can now be
cleaned while still fitted
to the cooker.
NEVER OPERATE THE COOKER
WITHOUT THE INNER DOOR GLASS IN
POSITION.
Refit the door inner glass as follows.
1.
NOTE:
The inner door glass has a special reflective
coating on one side. Replace the door inner glass
so that the statement:
„IMPORTANT THIS FACE
TOWARDS THE OVEN”
can be read from the inner
side of the door.
2. Turn the two securing brackets back to their origi-
nal position to retain the
glass and tighten the
screws (Fig. 2.)
