28
Care and Cleaning
Take particular care not to damage the inner surface of the door inner glass that is
coated with a heat reflective layer. Do not use scouring pads, or abrasive powder,
which will scratch the glass. Ensure that the glass panel is not subjected to any sharp
mechanical blows.
Stubborn stains can be removed by using a fine steel wool pad. For slight soiling the inner
glass panel may be cleaned, while still warm, without removing it from the door. After
cleaning, rinse and dry with a soft cloth.
CLEANING THE DOORS
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop down doors, except take care to
support the weight of the inner glass when removing and refitting.
DROP DOWN DOORS
Remove the door inner glass as follows.
1.
Open the door fully and unscrew the two screws securing the glass panel so
that the securing brackets can be turned. There is no need to remove the
screws completely.
2.
Turn the brackets so that the glass can be
removed and cleaned at the sink (Fig. 1.)
3.
The inside of the outer door glass can now be cleaned while still fitted to the
cooker.
NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS IN
POSITION.
Refit the door inner glass as follows.
1.
NOTE:
The inner door glass has a special reflective coating on one side. Replace
the door inner glass so that the statement: “IMPORTANT THIS FACE TOWARDS
THE OVEN”
can be read from the inner side of the door.
2.
Turn the two securing brackets back to their
original position to retain the glass and
tighten the screws. (Fig. 2.)
Fig. 1.
Fig. 2.
