Page 7
W
ater
Q
ualIty
and
m
aIntenance
BASIC INFORMATION
It’s important to have clean water. Water maintenance is one of the
least understood, yet most important, areas of spa ownership. your
dealer can guide you through the process of achieving and maintaining
perfect water in your spa, given your local conditions.
ImporTanT:
Water Terminology can be found at the end of this
section.
•
always
read &
refer to the owner's manual
for complete
information.
•
Test your water
with a test strip once a week, or each time the spa
is used.
•
add chemicals
in frequent small amounts to prevent overdosing the
spa.
•
use the spa only
when the chlorine level is between 1-5 ppm or
manually add chlorine as needed.
•
When using aCe
®
system
, read & refer to the Ace owner's manual.
•
It is the spa owner's responsibility
to prevent over or under
chlorination.
•
drain & refill water
2-4 times per year depending on how often you
use your spa, and how many people use it.
check with your Hot Spring
®
dealer to determine if water in your region
has unique qualities - such as high metal or mineral content - that
should be addressed.
your program will depend on your water’s mineral content, how often
you use your spa, and how many people use it.
WaTer QualITy CHarT
PARAMeTeR
TARgeT
MIN - "ok" RANge - MAx
pH
7.4
7.2
7.6
AlkAlINITy
80 ppm
40 ppm
120 ppm
HARdNeSS
100 ppm
50 ppm
150 ppm
cHloRINe
3 ppm
1 ppm
5 ppm
Maintaining the water quality and the cleanliness of the filters in
your spa is your responsibility. keeping the spa water balanced
prolongs the life of the spa components and will make the water
more comfortable. your dealer can guide you through the process of
achieving and maintaining perfect water in your spa, given your local
conditions. your program will depend on your water’s mineral content,
how often you use your spa, and how many people use it. Watkins
Manufacturing corporation has developed several water care systems
and products to simplify water care which are available from authorized
Hot Spring dealers
Ace Salt Water Sanitizing System
Vanishing Act
®
calcium Remover
Hot Spring FreshWater products
FreshWater 5-way Salt Test Strips
everFresh
®
System
clean Screen
®
Prefilter
ChEMICAl SAFETY
When using chemicals, read the labels carefully and follow directions
precisely. Though chemicals protect you and your spa when used
correctly, they can be hazardous in concentrated form. Always observe
the following guidelines:
•
Allow only a responsible person to handle spa chemicals. keep them
out of the reach of children.
•
Accurately measure the exact quantities specified, never more. do not
overdose your spa.
•
Handle all containers with care. Store in a cool, dry, well ventilated
place.
•
Always keep chemical containers closed when not in use. Replace
caps on their proper containers.
•
don't inhale fumes, or allow chemicals to come in contact with your
eyes, nose, or mouth. Wash your hands immediately after use.
•
Follow the emergency advice on the product label in case of
accidental contact, or if the chemical is swallowed. call a doctor or the
local Poison control center. If a doctor is needed, take the product
container along with you so that the substance can be identified.
•
don't let chemicals get on surrounding surfaces or landscaping. don't
use a vacuum cleaner to clean up chemical spills.
•
Never smoke around chemicals. Some fumes can be highly
flammable.
•
don't store any chemicals in the spa equipment compartment.
hOw TO Add ChEMICAlS
TO ThE wATER
ImporTanT:
All spa water chemicals, including granulated dichlor,
MPS, granulated pH increaser or decreaser, granulated total alkalinity
increaser, liquid stain and scale inhibitor, and liquid defoamer must
always be added directly into the filter compartment while the jet pump
is running in its high speed mode, and it must run for a minimum of ten
minutes.
To administer spa Water Chemicals:
1. Fold back the cover. carefully remove and set aside the filter
compartment cover.
2. on your control Panel, push the cleAN soft button (on home screen)
to turn on the jet pump.
3. carefully measure the recommended amount of chemical and slowly
pour it into the filter compartment. use care not to splash chemicals
on your hands, in your eyes, on the spa shell surface, or on the spa
cabinet.
4. Replace the filter compartment cover. After ten minutes, the jet pump
will automatically shut off to complete the procedure. close and secure
the cover.
danGer:
Risk of drowning: Never leave an open spa unattended!
ImporTanT:
After administering a super chlorination treatment or
non-chlorine shock to your spa, leave the cover open for a minimum
of 20 minutes to allow the oxidizer gas to vent. A high concentration of
trapped oxidizer gas which may exist as a result of the shock treatment
(not daily sanitation) may eventually cause discoloration or vinyl
degradation to the bottom of the cover. This type of damage is considered
chemical abuse and is not covered under the terms of the limited warranty.
Water Quality and Maintenance
