Page 36
LIGHT CONTROL
The intensity of the spa’s light is controlled using the LIGHT plus (+) or LIGHT minus (-) buttons.
To turn on the spa light, press the LIGHT plus (+) button. The light will turn on at maximum intensity and the light
symbol will illuminate on the control panel display.
To reduce the intensity of the light, press the LIGHT minus (-) button. The intensity of the light will
decrease each time the button is pressed. Additionally, if either of the LIGHT buttons (+ or -) on
the Main Control panel only, are held down, the light intensity will increase or decrease at the
rate of one intensity level every half-second.
To turn off the light, hold the LIGHT minus (-) button. The light will dim and turn off. When the light
turns off, the light symbol on the display will also turn off.
If the light is left on, it will automatically be turned off by the control system after six hours of continuous operation. The light symbol on the panel
will also turn off when the light is deactivated.
If the light will not turn on, make sure SPA LOCK is deactivated. SPA LOCK disables the controls on both the
main and auxiliary control panels.
WATER CARE
If your spa is equipped with a FreshWater
®
III high output ozone system, the Water Care
display will illuminate whenever the ozone system is running and the screen is not blank.
Should a problem occur with the ozone system, the display will flash off and on. See
FRESHWATER
®
III OZONE SYSTEM section for more information.
SUMMER MODE DISPLAY
The Summer Mode symbol is on when the Summer Mode timer is on. When activated, the symbol
will be visible even in bright light when the main display backlight is off. In low light conditions, the
Summer Mode symbol will only be visible when the display is activated by pressing a control
panel button.
AUXILIARY CONTROL PANEL
The auxiliary control panel, conveniently located in the spa seating area (Landmark
®
, Grandee
®
, Vanguard
™
, Sovereign
®
, and Prodigy
®
models),
allows the user to activate the jets and light from inside the spa.
NOTE:
Keep in mind that the auxiliary control panel will not function if the SPA LOCK feature on the main control panel has been activated.
JETS CONTROL
There is one button (two buttons on Landmark
®
and Grandee
®
models) which affects the jet pump(s):
The JETS button (all models) / JETS 1 (Landmark
®
and Grandee
®
models only) activates the jet pump. When the JETS or JETS 1 button is
pressed, the jets symbol will illuminate on the main control panel display. The symbol will remain lit until the button is pressed again to turn off the
jet pump, or after two hours of continuous operation when the pump is automatically shut off by the control system.
The JETS 2 button (Landmark
®
and Grandee
®
only) activates the second jet pump. When the JETS 2 button is pressed, the jets symbol will illuminate
on the main control panel display. The symbol will remain lit until the button is pressed to turn off the jet pump, or after two hours of continuous
operation when the pump is automatically shut off by the control system.
If the jet pump will not engage, make sure SPA LOCK is deactivated. SPA LOCK disables the controls on both the main and auxiliary control
panels.
Vanguard
™
, Sovereign
®
Limited Edition,
Sovereign
®
, and Prodigy
®
Landmark
®
and Grandee
®
Operating Instructions
