8.914-355.0 • Rev. 07/17
OPERATOR’S MANUAL
PRESSURE WASHER
8
Bolts, Washers
and Flange Nut
Handle
Figure 3 - Handle Installation
Unpacking
Unpack carefully. Wear safety glasses or goggles while
unpacking, assembling or operating pressure washer.
If there are missing components or hidden damage
immediately contact distributor or carrier concerning
discrepancies.
1. Cut strapping band from pressure washer and pallet.
2. Remove pressure washer from pallet.
Parts Included
•
Pressure Washer
•
Pressure Hose/Trigger Gun Assembly
•
Wand Assembly
•
Handle
•
Envelope Including:
■
Bolt 5/16" - 18 x 2" (5 ea.)
■
Flange Nut 5/16" - 18 (7 ea.)
■
Flat Washer 5/16" (5 ea.)
■
Operating Instructions/Parts Manual
Tools Required
•
10" Adjustable Crescent Wrench (2 ea.)
•
Teflon Tape
Pressure Hose, Trigger Gun and Wand
1. Use teflon tape on plumbing connections to prevent
leakage.
2. Install pressure hose on machine as shown in
Figure 1.
3. Attach the wand assembly to the pressure hose/trigger
gun assembly as shown in
Figure 2.
Handle
1. Remove plastic tubing from ends of handle.
2. Insert the handle through the holes in the chassis as
shown in
Figure 3
. Use the bolts, washers and nuts
from envelope to secure the handle to the chassis.
ASSEMBLY INSTRUCTIONS
Figure 1 - Pressure Hose Installation
Pressure
Hose
Relief Valve
Figure 2 - Wand/Trigger Gun Assembly
Wand
Assembly
Pressure Hose/
Trigger Gun Assembly
