5
HZE-1500P Installation
HZE-1500P Wiring Schematic
(see page 6 for instructions)
PEDESTAL ASSEMBLY
The unit should be assembled in an
area where it can be tipped down.
1. Insert the power cord through the
hole in the center of the base and
then through one of the two
identical poles (lower end is
threaded on the outside).
2. Insert the lower end of the pole
into the center of the base and turn
to tighten.
3. Insert the power cord through the
other identical pole (lower end has
threads on the outside).
4. Insert the lower end of the middle
pole into the upper end of the
bottom pole and turn to tighten.
5. Insert the power cord through the
top pole (lower end has threads on
the outside; upper end has bracket).
The cord must exit the pole through
the hole near the top, as shown.
6. Insert the lower end of the top
pole into the upper end of the middle
pole and turn to tighten.
7. Place the short stub that connects
the junction box to the heater body
in the bracket on the top pole. Place
the small bracket piece over the stub
and insert two allen screws. Use the
allen wrench provided to tighten
these screws which hold the heater
on the pedestal.
8. Remove the four Phillips head
screws that hold the junction box
cover in place.
The heater is ready to be wired.
Follow the Wiring Instructions on
page 6, then return to this page.
9. Use the four Phillips head screws
removed earlier to attach the
junction box cover, as shown.
10. Be sure the heater is still firmly
attached to the pedestal, then tip it
upright and plug it in to test
operation.
** The heater MUST be secured to the pedestal
BEFORE the power cord is attached. **
** All three pedestal poles MUST be used. **
