Commands
Command
Number of
blinks on hold
Description
Network status
4
Information about the presence of a configured
ZigBee network.
Binding
5
Binding with another ZigBee device.
Duration: until 60 seconds have elapsed or the
command ends.
Allow joining
6
Opening the ZigBee network for new devices to
join.
Duration: 60 sec.
Join network
7
Joining an existing ZigBee network. The device
makes 4 consecutive attempts.
Leave network
8
When leaving a network, the device goes to its
factory default settings.
Form network
9
Creates its own ZigBee network.
Lock/Unlock
10
Deny/Allow configuration changes.
Change PIN code
11
Configures a new PIN code
Enable/Disable backlight
12
Deny/Allow blue backlight
Network status
1.
Submit network status command by pressing the button and wait for 4 blinks.
2.
The blue LED indicator will start blinking SLOWLY:
2 times if the device is not part of a Zigbee network.
4 times if the device is connected to a ZigBee network.
Binding
1.
Submit a binding command by pressing the button and wait for 5 blinks.
2.
The blue LED indicator will start blinking FAST for 1 minute or until the command is
completed.
3.
Follow the binding instructions of the device you want to control the plug with. It must be
part of the same ZigBee network.
Alternatively:
When both devices you want to bind are part of a Houseper system, binding can
be done via the Houseper app.
* To execute this command, the device must be part of a ZigBee network.
Allow joining
1.
Submit allow joining command by pressing the button and wait for 6 blinks.
