Hoval TopVent TV, Operating Manual

5.3  Installation

Caution 

Risk of injury caused by falling load and improper handling. During 

 installation:

– 

Wear protective equipment (fall protection, safety helmet, safety shoes).

– Do not stand under suspended loads.

– Use cranes or forklifts with sufficient load-bearing capacity.

Preparation

■ 

Make sure that the following items are on hand for the assembly:

– 

Installation platform

– 

Drill Ø 16 mm

– 

Socket wrench, width 17

– 

Socket or open-end wrench, width 13

Installation

■ 

Install the retaining bracket:

– 

Cut 1 opening at the top and at the bottom of the casing with the drill (Ø 

16 mm, see   in Fig. 5).

– 

Insert the assembly bush 

into the top opening.

– 

Position the retaining bracket   over the openings.

– 

Insert M10 screws 

into the bushes.

– 

Turn the retaining bracket to the desired position in relation to the unit.

– 

Tighten the screws to secure the position.

– 

Place the plugs 

on the retaining bracket.

■ 

Install both mounting angles   with the M8 screws onto the retaining bracket.

– 

3 different inclination angles can be used.

■ 

Install the unit on the wall or on the ceiling (on-site fastening material).

– 

Use the packaging box as a drilling template.

± 60°

Fig. 4:  Angle of rotation, left/right 60°

M8 screw with spring washer, nut 

and washers (2 sets)
Mounting angles (x2)
Retaining bracket
M10 screw (x2)
Plug (x2)
Assembly bush

Opening

Fig. 5:  Unit installation

TopVent

®

 TV

Transport and installation

Art.No. 4 216 284-en-01 / Page 10