• Select “Auto Scan” at the top of the screen and turn on your Helios.
• Select “Enable Bluetooth”, and then click “Start Scanning”.
• After searching, Helios should appear. Click “Next”.
WARNING
Any Helios that does not work
properly can cause you to lose
control and fall. Inspect the entire
E-Scooter thoroughly before every
ride, and do not ride it until any
problems have been corrected.
• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris, or dirt inside the port.
• Plug the charger into a grounded wall outlet.
• Connect the cable with the power supply.
• Align and connect the 1-pin charging cable into the charging port of the
Helios (DO NOT FORCE OR BEND THE CHARGING CABLE AS IT MAY
CAUSE THE PRONGS TO BEND OR BREAK).
• The charging indicator light on the charger itself should change to red,
indicating that your E-Scooter is now being charged.
• When the red indicator light on your charger changes to green, then
your E-Scooter is fully charged.
• After fully charging your Helios, unplug the charger from it and from the
power outlet.
Only use the included charging
cable and charger to charge
your Helios. Using any other
charger may damage your
Helios.
CAUTION
CHARGING YOUR HELIOS
L
20