6
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
TURNING YOUR DEVICE ON/OFF
Power On: Place your Sypher flat on the floor and press the power button
(located on the rear of your Sypher) once. Check the LED indicator
(located in the center of your Sypher). The battery indicator should be lit,
indicating the Sypher is powered on.
Power Off: Press the power button once.
MAT SENSORS
There are four sensors under the foot mats of your Sypher.
When riding the hoverboard, you must ensure you are stepping on the foot
mats. Do not step or stand on any other area of your hoverboard.
The hoverboard may vibrate or spin in one direction if weight and pressure
are applied to only one foot mat.
BATTERY INDICATOR
The display board is located in the middle of the Sypher.
• A green LED Light indicates the hoverboard is fully charged.
• A red flashing LED light and beeping indicates low battery.
• A yellow flashing LED light indicates the hoverboard is charging.
When the LED light turns red, please recharge the Sypher.
RUNNING INDICATOR
When the operater triggers the foot mats, the running indicator LED will
light up, which means that the hoverbaord has entered the running state.
When the hoverboard encounters an error during operation, the running
LED light will turn red (for more details, see “SAFETY ALERTS” on page 16).
CONTROLS AND DISPLAY