6.
Level the Cabinet.
If your cabinet has double doors, proceed to
Step 7. For all other cabinets, place a level alongside the cabinet
from front-to-back and side-to-side (Figure 6). There are adjustable
levelers under the cabinet (Figure 1) that can be turned in (up)
or out (down) to make adjustments. Adjust the levelers until the
cabinet is level in all directions, and is square and firm on the floor.
7.
Cabinet Door Alignment.
To align the door gap at the top (Figure 7),
press up on the top left corner of the cabinet (Figure 8). If the door
alignment improves, turn the front left leveler counter-clockwise
until the doors align. If the door alignment becomes worse, press
up on the right corner of the cabinet and turn the front right leveler
counter-clockwise until the doors are aligned. This will require two
people.
Usually only one front leveler will need to be adjusted. However,
this method can be used to adjust the other levelers. Once the top
gap is aligned (Figure 9), the doors should operate correctly. Note
that the gap between the two doors cannot be adjusted with the
levelers.
The back levelers may need to be adjusted if the doors are not flush.
Follow the same procedure above on the back levelers to make the
door fronts flush with one another.
The cabinet will settle into the carpet and padding, which may affect
alignment. Realign if necessary. Note that carpet is commonly held
in place by tack strips around the perimeter of the room. Place your
cabinet so the base is at least 1 inch away from the wall to avoid
resting on the tack strip.
8.
Light and Power Supply Instructions.
Some cabinets include a
light and/or a power supply strip. Plug in all cords before using the
cabinet. The light is activated by a pessure switch located behind
the door in the upper left side of the cabinet, as shown below.
Open the left cabinet door. If the light does not turn on
automatically, turn the rotary switch on the light housing as shown
below.
FIGURE 6
FIGURA 6
FIGURE 6
ABBILDUNG 6
Door Activated
Pressure Switch
Rotary Switch
On Light
Power Supply
FIGURE 7
FIGURA 7
FIGURE 7
ABBILDUNG 7
FIGURE 8
FIGURA 8
FIGURE 8
ABBILDUNG 8
FIGURE 9
FIGURA 9
FIGURE 9
ABBILDUNG 9
2
