_ 07
User manual HJA8501 / HJA8511
03 - Installation
To make the product ready for use, review the
information in the user manual and make sure
that the electricity, tap water supply and water
drainage systems are appropriate. If they are not,
call a quali
fi
ed technician and plumber to have any
necessary arrangements carried out.
Preparation of the location and electrical, tap
water and waste water installations at the place of
installation is customer’s responsibility.
Installation and electrical connections of the
product must be carried out by the suitably quali
fi
ed
persons. Manufacturer shall not be held liable for
damages that may arise from installation
procedures.
Prior to installation, visually check if the
product has any damage on it. If so, do not have it
installed. Damaged products may cause risks for
your safety.
Make sure that the water inlet and discharge
hoses as well as the power cable are not folded,
kinked or crushed while pushing the product into its
place after installation or cleaning procedures.
Appropriate installation location
•
Place the machine on a rigid
fl
oor. Do not
place it on a long pile rug or similar surfaces.
•
Total weight of the washing machine - with
full load - is approx. 80 kilograms. Place the
product on a solid and
fl
at
fl
oor that has
suf
fi
cient load carrying capacity!
•
Do not install the product where temperature
may fall below 0ºC.
•
Place the product at least 1 cm away from the
edges of other furniture.
Removing packaging
reinforcement
Tilt the machine backwards to remove the
packaging reinforcement. Remove the packaging
reinforcement by pulling the ribbon.
Removing transportation locks
Do not remove the transportation locks before
taking out the packaging reinforcement.
Remove the transportation safety bolts
before operating the washing machine, otherwise,
the product will be damaged.
1.
Loosen all the bolts with a spanner until they
rotate freely (C).
2.
Remove transportation safety bolts by turning
them gently.
Installation