08_
Built-In
Appliances
Installation
3.
Attach the plastic covers supplied in the User
Manual bag into the holes on the rear panel.
Keep the transportation safety bolts in a safe
place to reuse when the washing machine needs to
be moved again in the future.
Never move the product without the
transportation safety bolts properly
fi
xed in place!
Connecting water supply
The water supply pressure required to run the
product is between 1 to 10 bars (0.1 – 1MPa). It is
necessary to have 10 – 80 litres of water
fl
owing
from the fully open tap in one minute to have your
machine run smoothly. Attach a pressure reducing
valve if water pressure is higher.
Models with a single water inlet should not be
connected to the hot water tap. In such a case the
laundry will get damaged or the product will switch
to protection mode and will not operate.
Do not use old or used water inlet hoses on the
new product. It may cause stains on your laundry.
1.
Connect the special hose supplied with the
product to the water inlet on the product.
Ensure that the cold water connection is made
correctly when installing the product.
2.
Tighten hose nut by hand. Never use a wrench
when tightening the nut.
3.
Open the tap completely after making the
hose connection to check for water leaks at
the connection point. If any leaks occur, turn
off the tap and remove the nut. Retighten
the nut carefully after checking the seal. To
prevent water leakages and damages caused
by them, keep the taps closed when the
machine is not in use.