37
8.2
DISMANTLING 163 COMPRESSOR FOR MAJOR OVERHAUL (Continued)
Removing the Inlet End Cover (WRV163mm)
Fit an eyebolt into the tapped hole at the top of the inlet cover flange.
Attach a sling to the eyebolt and support the weight of the cover using some form of lifting gear (Fig.
43).
Fig. 43
Fig. 44
Extract most of the screws securing the inlet cover to the main casing. Remove the dowel pins
locating the inlet cover to the main casing (Fig.44). Remove the rest of the screws and carefully
slide the inlet cover over the extended shaft of the male rotor, taking the ‘O’ ring seal with it taking
great care to avoid damaging the inlet end journal bearings, which are situated in the inlet end cover
(Fig. 45).
Fig. 45
Summary of Contents for WRV
