33
9.2.5. Alarm
Alarms include: I/O alarm, speed alarm, G-sensor, motion detection, alarm voltage, Fatigue,serial
port and PTZ control management.
9.2.5.1. IO Alarm (
ME40-04 supports 4 I/O ports only
)
IN1-IN6 is for generally use (same with the I/O serials cable ), IN7 and IN8 are for iButton,
it must be
OFF
status if you don’t use them
. (
on I/O serials cable , it is IN7 and IN9
)
Enable:
Press
【
Enter
】
key to select: off / emergency / front door / middle door / back door / driver door
/ other doors / low beam light / high beam light / turn right light / turn left light / brake / back / Customer
definition(Press
Info
key to call out the keyboard for new firmware).
Level:
Press
【
Enter
】
to select: high / low.
High
means it will trigger sensor alarm when the voltage of sensor input is changed from 0 to a high
voltage[DC 4V - 12V].
Low
means it will trigger sensor alarm when the voltage of sensor input falls from a high voltage[DC
4-12V] to 0 .
Delay:
The alarm duration time after trigger source is removed, it is used for setting linkage’s duration
time. During this period, it will not response the new alarm if there is a continuous triggering on the I/O
port.
