Hozelock Cyprio Vorton Instructions Manual Download

Page: 3 / 28

HOZELOCK CYPRIO 2 YEAR

GUARANTEE

If this Vorton UVC (excluding Lamp)
becomes unserviceable within 2
years of the date of purchase it will
be repaired or replaced at our
option free of charge, unless in our
opinion it has been damaged.

Liability is not accepted for damage
due to accident, improper
installation or use. Liability is limited
to replacement of the faulty unit.
This guarantee is not transferable. It
does not affect your statutory rights.

To obtain the benefits of this
guarantee, firstly contact Hozelock
Cyprio Consumer Services who may
request that the unit is sent along
with proof of purchase directly to
the address below.

Hozelock Cyprio

Midpoint Park, Birmingham B76 1AB.
England.
Tel: +44 (0)121 313 1122
www.hozelock.com

7 CHECKLIST

7.1 If your Vorton fails to produce clear

water, please check the following
table before contacting the Helpline

HOZELOCK CYPRIO CLEAR WATER

GUARANTEE

WE GUARANTEE YOU CLEAR WATER
OR YOUR MONEY BACK for a
Hozelock Cyprio Vorton UVC when
used with a correctly sized Hozelock
Cyprio filter. This guarantee runs for
12 months after purchase, provided
that

* You have followed the installation
and operating instructions.

* You are using equipment of the
correct size, according to Hozelock
Cyprio’s sizing information.

* You consult our Helpline (0121 313
1122 ) early enough for any
problems to be put right.

* The product has been returned
undamaged.

A refund can only be authorised by
Hozelock Cyprio and is made only at
the place of purchase to the value of
the purchase price of the filter and
UVC only.

Please note that the Clearwater
Guarantee does not cover loss of
water clarity when blanketweed, as
opposed to greenwater algae, is the
cause.

UVC treatment in winter is optional,
but if there is any risk of freezing,
the unit should be switched off,
drained and removed. This will
prevent damage to the product.

5 MAINTENANCE

Always disconnect the electricity
supply before starting to handle,
maintain, repair or install any
equipment in the pond.

5.1 To fit the lamp:

i) Remove the screw securing the
electrical head ( See fig 5 ). Turn the
head anti-clockwise, pull out and
then turn clockwise. The head
should then pull gently away from
the main body.

ii) Remove the quartz glass tube in a
similar way by removing the
retaining screw, rotating the plastic
moulding anticlockwise and pulling
away from the body, (see Fig 6 ).

iii) With the lamp holder now
accessible, push the lamp into
position.

iv) Re-assemble the quartz tube into
position ensuring the screw boss is
re-aligned and screw refitted.

v) Re-assemble the head to the body.
Using the alignment marks ‘A’ (see
fig 5), press together while rotating
anticlockwise allowing to slot
together, then rotating clockwise.
The screw boss should realign,
allowing the retention screw to be
re-fitted.

5.2 Important: Refer to section 1 - Safety

and Electrical Connections before
attempting any maintenance.

5.3 How well your Vorton UVC performs

is related to the strength of the UV
radiation produced. This will slowly
decline from the day your lamp(s)
are fitted. The UVC lamp has an
effective life of 12 months. You need
to change the lamp when there is a
significant reduction in water clarity.
Make sure this is due to an expired
lamp and not a badly maintained
filter or a dirty/limescaled quartz
sleeve. Both can greatly reduce UV
transmission into the water.

5.4 Especially in hard water areas, the

quartz tube may become covered in
limescale, which will reduce
efficiency. To gain access to the tube
and lamp refer to section 5.1. Clean
the tube with a soft cloth and a
gentle de-scaler, rinse in water
before refitting. DO NOT SUBMERSE
THE UNIT IN WATER.

5.5 Change the lamp at the start of the

new season. Even though the lamp
still glows it may not be giving out
any useful UV radiation.

5.6 Wash out the inside of the main

body to remove dirt and debris.

5.7 Always check the system thoroughly

for leaks when restarting.

6 WINTER STORAGE

6.1 When not in use, the unit should be

removed, thoroughly washed, dried
and stored in a dry frost protected
area.

Make sure that parts of the translucent hosetails
are visible, so that you can see a bluish glow. This
may be easier during late evening as it gets dark.

Keep a record of the date the lamp was installed.
We recommend a new lamp be fitted at the start
of the new season.

Refer to section 5.3.

All the pond water should pass through the
Vorton UVC once every 1 1/2 - 2 1/2 hours. i.e. a
10,000 ltr pond needs a flow rate of between 4000
and 6000 ltr/hr, while trying to achieve as near to
the upper limit as possible.

Inspection.- This is to prevent short-circuiting of
the filtration system. - The same water being
filtered over and over again, while other areas of
the pond remain static and unfiltered.

CHECK

HOW

The UVC lamp is on and
glowing.

The age of the lamp.

The Quartz Sleeve is clean.

That the pump is delivering
sufficient flow of water.

The pump is at the opposite
end of the pond to the
outlet of the filter

Description

Vorton

4500

14000

27000