The Bell Fountain creates a decorative
waterbell. The size of the bell can be
adjusted to suit your needs by rotating
the Fountain Flow Adjuster (Fig 3-K).
(Fig 4-B for general installation guide)
Position the pump as previously
described.
Attach a suitable length (3m maximum)
of 25 mm (1”) hose to the waterfall
hose tail (Fig 1-G) and secure with a
suitable hose clip and position the
outlet end of the hose in the desired
position.
Screw the waterfall hose tail to the
fountain outlet of the EasyClear™ (Fig
1-A) and adjust the flow using the
fountain flow adjuster, (Fig 3-K), to suit
your needs.
Note: The maximum recommended
waterfall height above pond level is
0.5m (Fig 4-B).
The UVC will automatically switch on
once the unit has been connected to
the electricity supply.
The UVC lamp can be checked for
operation by looking for a bluish glow
from ball joint outlet (Fig 1-A). Please
note that this may only become visible
in low light conditions.
See Maintenance section for Lamp
replacement.
The Hozelock Cyprio EasyClear™ has
been designed to allow fast and easy
maintenance. As with all pond
equipment, occasionally it will become
necessary to clean or replace parts.
Refer to the safety sections before
attempting any maintenance.
Fountain Head (Fig 1-I)
Follow the below procedure if the
fountain head is blocked:
1 - Place a coin or similar in the slot
and gently lever off the fountain head.
2 - Rinse in clean water and
reassemble.
Foam
Follow the below procedure if flow
appears reduced:
1 - Release the Foam Cover by pushing
the two buttons (Fig 5-M) and lift the
cover (Fig 6-N).
2 - Remove the Foam (Fig 7-O). Note:-
If the unit is out of the pond for more
then 20 minutes the biological filter
action may stop working.
3 - The Foam Cover and Base should
also be rinsed.
4 – It may also be necessary to clean
out the biomedia and stones (Fig 7-P) if
these have become clogged.
5 - Reassemble the Filter.
Quartz Tube
Follow the below procedure if your
pond remains green:
1 - Remove the bayonet locking screw
(Fig 8-Q), twist and lift the bayonet
tube (Fig 8-R).
2 - Clean the Quartz Tube. Take extra
care when handling the Quartz tube. In
hard water areas, the quartz tube may
become covered in limescale, which
will reduce efficiency. Clean the tube
with a soft cloth and a gentle de-scaler
(such as vinegar and water), rinse in
water before refitting.
3 – Reassemble the bayonet tube and
Maintenance
UVC Operation
Waterfall Only
Operation
