MultiDAT iPAQ based shuttles
4
Changing the default communication mode
If, for any reason, you need to communicate with a MultiDAT that has been configured to work in a
different communication mode (ex: wireless radio modem or satellite mode) with the MultiCOM software,
you can do so by following these steps (To switch between NORMAL, MAXSTREAM or SATELLITE
mode):
•
Connect the shuttle to the datalogger as shown above.
•
Run
MDAT.
•
Tap
the
Preferences
button with the stylus.
•
Tap
the
Advance settings…
button with the stylus.
•
Using
the
Communication mode
dropdown list, select one of the new communication modes
•
Tap
the
OK
button with the stylus.
This operation will tell the IPAQ that further communications with the MultiDAT should only be done in the
new selected communication mode. In order to come back to the default cabled communication mode,
follow the same procedure and choose the
Normal Cabled
mode.
PLEASE NOTE: THAT YOU NEED MDAT SOFTWARE 1.2 (BUILD 7) or higher available on the FERIC
website to access this feature.
