2
.
Remove the two black Phillips PM2.5×4.0 screws
(2)
that secure the system board to the computer.
3
.
Use the optical drive connector
(1)
to lift the right side of the system board until it rests at an angle.
4
.
Release the system board
(2)
by sliding it to the right at an angle until the connectors on the left side
of the system board disengage from the base enclosure.
5
.
Remove the system board
(3)
.
6
.
If it is necessary to replace the modem module cable, remove the RJ-11 connector
(1)
from the clip
built into the base enclosure.
74 Chapter
4
Removal and replacement procedures
ENWW
Summary of Contents for V3000
