7
.
Remove the modem module cable
(2)
from the routing channel built into the base enclosure. The
modem module cable is included in the Cable Kit, spare part number 430474-001.
When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
●
ExpressCard assembly (see
ExpressCard assembly on page 75
)
●
Fan/heat sink assembly (see
Fan/heat sink assembly on page 78
)
●
Processor (see
Processor on page 81
)
Reverse the preceding procedure to install the system board.
ExpressCard assembly
Description
Spare part number
ExpressCard assembly
417112-001
Before removing the ExpressCard assembly, follow these steps:
1
.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2
.
Disconnect all external devices connected to the computer.
3
.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4
.
Remove the battery (see
Battery on page 36
).
5
.
Remove the following components:
a
.
Hard drive (see
Hard drive on page 37
)
b
.
Optical drive (see
Optical drive on page 44
)
c
.
Keyboard (see
Keyboard on page 46
)
d
.
Switch cover (see
Switch cover on page 49
)
e
.
Display assembly (see
Display assembly on page 51
)
ENWW
Component replacement procedures 75
Summary of Contents for V3000
