To replace the component, reverse the removal procedure.
Removing and replacing an expansion slot blank
WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment, remove power from
the server by removing the power cord. The front panel Power On/Standby button does not shut off
system power. Portions of the power supply and some internal circuitry remain active until AC power is
removed.
CAUTION:
For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers,
or blanks installed. If the server supports hot-plug components, minimize the amount of time the access
panel is open.
Procedure
1.
Power down the server (
on page 36).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
• Extend the server from the rack (
Extend the server from the rack
on page 37).
• Remove the server from the rack (
Remove the server from the rack
on page 37).
4.
Remove the access panel (
on page 39).
5.
Remove the PCIe riser cage:
• Primary or secondary PCIe riser cage (
Removing and replacing the primary or secondary PCIe
on page 45)
Removing and replacing the tertiary PCIe riser cage
6.
Remove the expansion slot blank.
50
Removing and replacing an expansion slot blank
Summary of Contents for ProLiant DL380
