6.
7.
Remove the drive backplane.
To replace the component, reverse the removal procedure.
Removing and replacing a rear serial port interface (primary/
secondary)
Procedure
1.
Power down the server(
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
• Extend the server from the rack (
Extend the server from the rack
on page 37).
• Remove the server from the rack (
Remove the server from the rack
on page 37).
4.
Remove the access panel (
on page 39).
5.
Using a T-10 Torx screwdriver, remove the screws securing the serial port. Then, disconnect and remove
the serial cable.
Removing and replacing a rear serial port interface (primary/secondary)
67
Summary of Contents for ProLiant DL380
