Reverse this procedure to install the RTC battery.
Display assembly
NOTE:
The display assembly is spared at the subcomponent level only. For more display assembly spare
part information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
), and then remove the following components:
a.
Battery (see
)
b.
Solid-state drive (see
)
c.
WLAN module (see
)
d.
Power connector bracket (see
Power connector cable on page 36
)
e.
Fans (see
f.
System board (see
)
Remove the display assembly:
1.
Remove the three Phillips PM2.5×4.4 screws (1) that secure the display assembly to the keyboard/
top cover.
46
Chapter 5 Removal and replacement procedures
Summary of Contents for 13-d000
